|
1)Adjust the pressure of heat-press
board. Try the pressure first--put the cap on the base
board, press the handle. It will affect the quality of
finished product whether it's too tight or too loose. Adjust
the pressure by the button until suitable.
2)Remove the handle and the heating point. Get printing
stock out.
3)Press the red button, turn on power.
4)Set temperature and time according to different materials.
5)When it reaches desired
temperature, place the printing stock on the board and the
transfer paper in a proper place. Then put Teflon paper on
the top.
6)Remove the heating point up to
the base board. Screw the button and press the green button
and handle at the same time.
7)Upon hearing music, turn off the green button and lift the
handle.
8)Get printing stock out and a complete image will be on the
printing stock.
Tips:
(1)
In the process
of preheating, don¨t put the handle down unless the
temperature has reaches the setting degree.
(2)
There¨re two
ways to remove base paper！＾Hot-split￣ and ＾cool-peel￣.
Master the right time and temperature due to different
materials.
(3)
The machine
shows temperature in international standard of centigrade.
To avoid troubles, please be aware that different districts
uses different standard. Below is unit conversion chart
between centigrade and Fahrenheit. There is one such chart
on the machine.
F=1.8C+32
220C=428F 200C=392F 190C=374F
180C=356F 160C=320F 140C=284F
http://asc365.com |
