|
1)Adjust
the pressure of heat-press board. Try the pressure first--put printing
stock on the base board, press the handle. It will affect the quality of
finished product if it's too tight or too loose. Adjust the pressure by
the button until suitable.
2)Lift the upper board and get
printing stock out.
3)Turn on power.
4)Set the temperature and time
according to different materials.
5)When it reaches desired
temperature, place the printing stock on the board and the transfer
paper on a proper place. Then put Teflon paper on the top.
6)Press the handle down and the
timer will start to count. Upon hearing music, open the machine.
7)Get
printing stock out and a complete image will be on
the printing stock.
Tips:(1)
In the process of preheating, don¨t put the handle down unless
the temperature has reaches the setting degree.
(2)
There¨re two ways to remove base paper！＾Hot-split￣ and
＾cool-peel￣. Master the right time and temperature due to different
materials.
(3)
The machine shows temperature in international standard of
centigrade. To avoid troubles, please be aware that different districts
uses different standard. Below is unit conversion chart between
centigrade and Fahrenheit. There is one such chart on the machine.
F=1.8C+32
220C=428F 200C=392F 190C=374F
180C=356F 160C=320F 140C=284F
http://asc365.com |
