|
1) Make sure handle is in the "open" position Turn on
power switch.
2) Never close handle of press without a mug in it when
the power switch is "on".
This will cause early heater failure.
3) Set timer to 50 Second
4) Set temperature to 170C(340F) degrees.
5) Tape transfer to mug using one small piece of tape on each side of
the transfer .
When cutting the transfer to fit the mug, be sure to
leave ¼" on the top and bottom
of mug and ½" on the left and right of the handle.
6) Wrap mug and transfer with Teflon(Pellon) sheet.
7) Close the press handle. This will activate the heater.
8) Press ＾timer stop￣ button to stop timer count
9) When the temperature arrived at the temperature set,
the timer start to count
10) When the buzzer sounds, open the press and remove the
mug.
11) Using the scraper, push out any air trapped under the
transfer.
Use caution as the mug will be hot. Hold the mug by the
handle only.
12) Repeat steps 6, 7 and 8.
13) Remove the transfer from the mug. Again, use caution
as the mug is extremely hot!
If you have any questions or difficulties, please feel
free to Email :
weizhao100@hotmail.com
½" from handle tape ¼" from top and bottom
 |
