|
Application:
This is screen printer
with vacuum pallet, suitable for all kinds of high precision and
exquisite plane screen printing, especially for light and thin
materials like paper, plastic sheet, CD, credit card, PCB, and
all kinds of film, card, board and paper.
Also suitable for all kinds of transfer paper, PVC, PET, PC and
other soft/ hard film, board, paper, nameplate, and similar
materials.
It can also be used for the fine printing on heavy and thick
products, such as paper boxes, glass, wood boards, metal plates,
signage, various plastic boards and etc.
Not
suitable for cloth, ribbons, handkerchiefs and other textile
products, textile materials are recommended to use the scraping
pallet with glue.
Character:
1, The
printing object can be tightly adsorbed on the pallet, to
prevent the printing object moved by outside force.
2. After printing, vacuum
pallet can keep the printing object close to the pallet can
won't be lift up by ink.
3.
Equip with 3 gravity balance
plates, they can be installed individually or together according
to weight request, it can be moved forward and back within 4
inches (10cm ).
With the bolt in the balance rack, could
adjust the lifting angle and height of the screen frame.
Function:
This
screen printing table uses 2 mm stainless steel plate laser
cutting, table area is 40x50 cm; Vacuum area is 42x31.5 cm;
Suction hole diameter is 1 mm; The spacing of air holes is 15
mm. The quantity of air holes are 638 (22 rows in horizontal
direction and 29 rows in vertical direction).
Three-directions micro adjustable, it can be micro adjusted
through the knob up and down , forward and back 3/4 inch, left
and right 3/4 inch ;
Place
the substrate on the table surface and start the vacuum pump.
Clamp the screen frame after aligning the screen pattern with
the substrate.
Height adjustment: place the screen frame flat on the
platform. According to the substrate height or printing
requirements, rotate the up and down adjustment handle to reach
the appropriate height, and lock the height through the two rear
positioning handles.
Left
and right adjustment: loosen the handle on both sides of the
nose, and rotate the handle to move slightly left and right as
required; When it is done, tighten both handles.
Back
and forward adjustment: first, slightly loosen the four red
knobs on the front of the chuck, then loosen the fine-tuning
knobs on both sides of the front of the chuck and make front and
rear fine-tuning as required. After the fine-tuning, tighten the
knob and tighten the four red knobs on the top of the chuck.
When
substrate area is too small, adsorption will reduce, you can
cover the blowholes around the substrate with plastic sheets or
paper to increase the adsorption of substrate.
|
