|
(1)
Ink cup body: used to hold ink and install other parts on it.
(2) Ceramic circle: used to coat ink and is an important part.
It’s hard and has a good
abrasion
resistance,
but it is fragile too, so it's necessary to be protected well.
(3) Adjusting Circle: used to change the suction between ceramic
circle and printing board by adjusting the height of magnet.
When installing the inkcup onto the printing board or taking it
from the board, adjusting it to a smaller suction, you can move
it easily and also the ceramic circle and printing board
(especially for nylon board) will be much safer. Under ink is
cleaned all away, less suction can make ceramic circle and
printing board have a long life.
(4)
Plug screw: used to add Ink Thinner and exhaust.
(5) Magnet: used to stick the
ceramic circle on the printing board. When it leaves factory, it
has been installed in the iron pole.
|
 |
