(1) Check and clean up the machine to
make sure there are no foreign bodies before use.
(2) On 110v power supply, close the machine power master switch on
the right side.
(3) Turn right to stop switch, the power indicator (red) on.
(4) Adjust the thermostat preset temperature on the mould.
(5) Press the down key to test the machine. In order to adjust the
pizza crust thickness, let the above mold down to the bottom until
touch the limit switch on the left side and stop the machine.
(6) Display time controller shows the molding time. The above mold
automatically rise, back to the original position.
After checked above, put kneaded dough
evenly into the below mold, start the machine to begin pizza cone
production.
Note:
Only when the upper mold is fully raised can the lower mold be
opened to remove the cone, be careful not to get burned,If there
are some questions using the machine, please contact us. |
