|
1.First, make
the picture smooth and tight, take joiner to accurate (about 2-4cm),
fixed edges with tape or glue on the ground.
2.Set
temperature: connect
power, turn on the temperature knob (the golden knob) until it
click, and then press▲(▲for up ▼for down). In general, the
temperature is between 350-400℃，Or
to know it the temperature is ok, we can taking some waste banners to
aligned nozzle to test, If it can be melted immediately, This
temperature is the one you need and to set. if not strong just
increase
temperature, if
too hot, reduce temperature. check
photo below:
3.Set
wind speed:
in
general, we put wind speed to the largest. so just put wind speed to
the Maximum is ok.
4.Set
walking speed: Then
turn on waling knob to adjust the speed, generally marked on the
knob points to the location between 3 from 4.
5.Start
welding: when
actual temperature of the display screen reaches temperature that
you set, we can begin to weld. put operation handrail (at end of the
machine) to left, machine begin to work automatically.
6.During welding, let
hot air nozzle between two overlap pieces. And be make sure hot air
nozzle and Rubber wheel walk in straight line. if not, please adjust
by hand. check photo:
7.Finish
welding: turn
the walking handrail to the right ,machine stop walk, then turn off
the yellow button (temperature knob), but before cut off the
power, please wait until actual temperature below 50 ℃，then
we can cut of the main power, or it would be damage heat system.
8.
Don't use it in rainy day,the
workplace should be dry, flat and safety of fire.
The
machine should have technical person to operate,
it is forbid that someone use it
without specific knowledge. Working voltage：110V
Strictly prohibited without permission disassemble,
you
should be responsible the result yourself.
Please pay attention: In order to keep heat element, we add Automatic
Dormancy function, it means if not using welder over 10
minutes, machine would be enter dormancy state. if want it reback to
work, just press the
‘Reset’ button
or put the operation handle to right is ok, but it nee ds 1 minute to
raise the temperature, so we need to wait.
|
