In order to ensure the safety and normal operation
of the person and the machine, a special person shall be assigned to be
responsible for the storage and use of the machine. The machine shall
not be operated without learning this procedure and operation technology
and reading the familiar instructions.
1. In addition to commissioning according to the
commissioning method, before starting, the machine must be carefully
checked to see if there are tools and objects hindering the startup and
operation, and whether the upper casing is locked.
2. Before starting the machine, it is necessary to
check whether there are sundries in the machine. Except for processing
straw, nothing is allowed to be stacked on the feeding table.
3. Check whether the electrical equipment is normal
and safe.
4. Check whether the running direction of the main
shaft conforms to the direction indicated by the arrow on the casing. If
not, immediately adjust and close the power switch to ensure the correct
operation of the machine.
5. Run for 2-5 minutes before operation, check
whether the rotating speed meets the requirements of the machine, never
allow overspeed, and check whether other parts are abnormal. If
everything is normal, the feeding can be started, and the feeding cannot
be excessive, so as to prevent damage to the supporting power unit and
machine parts due to overload operation.
6. Feed crops evenly, not too much, so as not to
block the feed inlet. The operator's hand shall not be close to the
feeding belt during operation.
7. In case of blockage, stop the machine
immediately. After the machine stops stably, open the upper cover, clean
the blockage, and then restart.
8. Always pay attention to whether there is
abnormal sound during the operation of the machine. Shut down and power
off immediately in case of abnormality.
9. There shall be no mortar, sand, stone, iron
wire, tool parts or other sundries in the crops to be processed to avoid
damage to the machine or accidents.
10. At the end of each shift, the power supply must
be cut off after all the crops on the feeding table are fed and no more
materials are thrown out at the outlet.
12. When the machine is operating, it is forbidden
to stand at the grass outlet to prevent flying objects from hurting the
body.
13. Operators are not allowed to wear gloves,
sleeves must be fastened, and those with long hair must wear safety
helmets. All personnel must leave the rotating plane of belt and
rotating parts.