|
A. Installation Method
1. The machine should be installed in the
room with good ventilation and appropriate temperature
and without exposure to sun or rain. There should be a
stable and flat foundation, and the foundation screws
should also be tightened. There should be no vibration
or swing during use.
2. During installation, the center of the
belt pulley between the machine and the prime motor
should be aligned and placed straightly.
3. After the peeling machine is
installed, the idling test is conducted to check the
installation condition and the main shaft heating
degree, and please pay attention to whether the rotating
direction accords with the direction indicated by the
arrow.
B. Operation Method
1. Before processing, the raw grains
should be inspected, and no impurities are allowed to be
mixed with the raw grains. When peeling corn and wheat,
mix the raw materials with clean water, and wait for
about ten minutes before peeling, so as to ensure the
quality of peeling.
2. Open the machine cover, adjust the gap
between the cutter and the roller, check if the screen
bottom is intact and if there are any falling objects in
the working chamber, then close the machine cover,
tighten the hook screws, and close the sliding plate.
3. After starting the machine for half a
minute, slowly open the sliding plate, adjust the
discharge outlet, and process the grain.
4. When the processing operation is
completed or the machine stops halfway, the feeding
inlet sliding plate must be closed first, the machine
operates for about one minute, and then the power can be
cut off.
5. Adjust the gap (referring to the outer
diameter) of the roller by adjusting the screw.
Generally, the inlet is about 4-6 millimeters and the
outlet is about 2-3 millimeters. If finding that the
material is broken or the raw grain flows out, adjust
the cutter gap and the size of the discharge outlet in a
timely manner. The side, close to the feeding end, of
the cutter is prone to wear and tear, and the sides of
the cutter can be exchanged to be used. If there is
excessive wear and it is difficult to ensure the
processing quality, a new cutter should be replaced.
6. After the roller is used for a long
time, the peeling rate and accuracy of the roller will
significantly decrease due to excessive wear, and the
roller should be replaced in a timely manner.
7. If the machine is stuck, immediately
close the feeding inlet sliding plate, open the upper
cover, clean away the raw materials in the the machine
shell, rotate it smoothly, and then start the machine
again.
8. The rotating speed of the peeling
machine must be within the specified range, and then the
machine can be started, as the too high or too low speed
can affect the discharging quality and yield. If the
speed is too high, the raw grain is prone to flowing
out, and the quality will be reduced. The similar
situation may also occur if the speed is too low.
9. Special attention should be paid to
the adjustment of the rotating speed of the peeling
machine, the gap of the cutter and the size of the
discharge outlet, which are the three key factors
related to quality and output, and should be taken into
account.
10. If there are phenomenon that rice
grains are sucked into the bran or the grains cannot be
winnowed thoroughly in the working process, it is
necessary to carefully check whether the bran outlet
cloth bag is tightly tied or whether the filter sieve
air outlet is blocked. Otherwise, corresponding
troubleshooting should be carried out.
11. It is advisable to use a 2-meter
cloth bag for the air outlet. If the wind is low, the
bag can be lengthened. If the wind is strong, the bag
can be tied to be shorter. |
