|
*
screen frame is not included with this printer.
Application:
Suitable
for all kinds of flat product printing, such as electronic
circuit board, paper box, glass, board, metal plate,
scutcheon and all
kinds of plastic board, etc.
Do not
recommend to use this machine for cloth, ribbons, sashes,
paper, thin plastic sheets and other light materials. (These
materials are too thin, after printing, the screen frame may
stuck with the plate then mess up the printing result ).
Paper,
thin plastic sheets and other lighter materials are recommended
to use vacuum screen pallet ;
Cloth,
ribbon, and other textile printing is recommended to use the
wooden pallet with glue.
Character:
Printing head is micro adjustable in
three-directions, it can be moved in 4 directions by moving the
knob within 3/4 inch.
This machine is equipped with three gravity
balance plates, which can be installed individually or together
according to the request. The gravity balance plate can move
forward and backward in 4 inch.
With the screws under the balance frame,
the lifting angle and height of the screen frame can be adjusted
as required.
Equipped with full set installation tools.
Micro adjustment operation:
Height adjustment: Place
the screen frame flat on the platform. According to the
substrate height or printing requirements, rotate the handle up
& down to reach an appropriate height, then lock the height with
the two rear positioning handles.
Left and right adjustment: loosen
the handle on both sides of the press, and rotate the handle to
move slightly left and right as required, after adjustment
tighten both handles.
Back and forward adjustment:
First, slightly loosen that four red knobs overhead the
clamp, then loosen the metal knobs on both sides of the clamp
and move front and rear as required. After adjusting, tighten
the metal knobs and four red knobs on the top.
|
